- Load Capacity: 3kg (at max height)
- Max Height: 2400mm
- Min Height: 840mm
*Note that the stand will be able to hold heavier loads when not fully extended (~around 5kg).
*Note that the stand will be able to hold heavier loads when not fully extended (~around 5kg).
This aluminum Meking L-2400FP Light Stand rises to a height of 2400mm and folds down to 840mm. The stand has sure-twist section locks and 4 sections and will support up to 3kg (at the maximum height).
*Note that the stand will be able to hold heavier loads when not fully extended (~around 5kg).
The L/LT series light stands are Meking’s standard stands which hold small to medium sized lights with accessories. These are relatively lightweight stands which can be folded down to be transported around easily to use in various locations.
With a double sided spigot mount, this series of light stands can accommodate regular continuous lights and strobes while also allowing for any other models with a female 1/4” or 3/8” screw thread to be mounted.
The option to slot in the spigot at 90 degrees off (sideways) also gives you more possibilities in the angle the light is mounted onto the stand.
The air-cushioned feature (only the products ending with P) built into the stand ensures that the centre columns do not slam/slide downwards freely when released - this movement is heavily slowed. This helps to reduce the risk of injury when adjusting the height of the stand or packing/unpacking. If you forget to tighten any section with your light mounted, the light slowly descends, thanks to the air-cushioned action. This useful feature saves equipment and fingers from harm during busy photo sessions.
*Note: Please consider the use of a sandbag to balance your stand if you are using larger accessories on your light like softboxes/umbrellas to reduce the risk of toppling.
Minimum height: 840mm
Maximum height: 2400mm
Closed Length: 735mm
Leg: 22
Maximum Load: 3kg (at max height)
Footprint Diameter: 940mm
Minimum height: 840mm
Maximum height: 2400mm
Closed Length: 735mm
Leg: 22
Maximum Load: 3kg (at max height)
*Note that the stand will be able to hold heavier loads when not fully extended (~around 5kg).
Footprint Diameter: 940mm